- Release Notes and Announcements
- Product Introduction
- Purchase Guide
- Getting Started
- Public NAT Gateway Operation Guide
- API Documentation
- FAQ
- Service Level Agreement
- Contact Us
- Glossary
- Release Notes and Announcements
- Product Introduction
- Purchase Guide
- Getting Started
- Public NAT Gateway Operation Guide
- API Documentation
- FAQ
- Service Level Agreement
- Contact Us
- Glossary
After creating a NAT gateway, you can follow the directions to manage the EIPs of the gateway.
Directions
1. Log in to the NAT Gateway console.
2. Click the ID of the target NAT gateway to go to its details page.
3. Click the Bind EIP tab. On this tab, you can view the EIPs bound to the NAT gateway and manage them.
Binding EIPs
Note:
Loads are automatically balanced if the NAT gateway is bound to multiple EIPs.
Currently, you can bind the existing EIPs only. To bind more EIPs, create them first in the Public IP console.
1. Click Bind EIP on the top of the tab.
2. In the Select IP drop-down list, select the EIP or EIPs to be bound, and then click OK.
3. Click OK.
Adjusting the bandwidth of the EIP
1. Find the target EIP, click Adjust bandwidth under the operation column.
2. Adjust the bandwidth of the target in the pop-up window, and then click OK.
Unbinding EIPs
Note:
When the NAT gateway is bound with only one EIP, the unbinding is not supported.
1. Find the target EIP, click Unbind under the operation column.
2. In the Confirm unbinding pop-up window, click OK.
Yes
No
Was this page helpful?